Bylaw test
Top of page
Loading Stalls
123
1
A loading stall must be located so that all motor vehicles using the stall can be parked and maneuvered entirely within the boundary of the site before moving onto a street or a lane.
4
Wheel stops must not exceed 0.10 metres in height above the loading stall surface and must be placed perpendicular to the loading stall depth a minimum of 0.60 metres from the front of the loading stall.
5
In commercial, industrial, mixed use and special purpose districts the minimum requirement for loading stalls is:
a
1.0 loading stalls per 9300.0 square metres of gross floor area where the cumulative gross floor area of all buildings on a parcel is greater than 930.0 square metres; and
b
0.0 loading stalls where the cumulative gross floor area of all buildings on a parcel is less than or equal to 930.0 square metres.
6
Unless otherwise referenced in subsection (7), the following uses are not included in the calculation of required loading stalls:
7
Where a building contains 20 or more units with shared entrance facilities, a minimum of 1.0 loading stalls is required.
8
In a multi-residential district, where the cumulative gross floor area of commercial multi-residential uses exceeds 930.0 square metres, the commercial multi-residential uses require 1.0 loading stalls per 9300.0 square metres of gross floor area.