Bylaw test
Top of page
PART 11: CENTRE CITY DISTRICTS
Division 7: Rules Governing Centre City Bonus Overlays
General
1195
1
The floor area ratio of the CC-MH, CC-MHX, CC-X and CC-COR land use districts may be increased from the maximum floor area ratio listed in the district in accordance with the bonus provisions of this Division.
Bonus Area B
1198
1
Only developments containing units totaling a minimum gross floor area equal to a floor area ratio of 2.0 are eligible for bonusing under this Division.
2
Subject to subsection (1), the maximum floor area ratio with bonuses for Bonus Area B is 9.0 for developments containing units when the bonusable floor area ratio is provided as units.
Bonus Area D
1200
In accordance with the bonus provisions contained in this Division, the floor area ratio for Bonus Area D may be increased to a maximum of:
b
12.0, where the additional floor area ratio above 8.0 may only consist of units or Hotel guest rooms or both.
Bonus Area F
1201.1
In accordance with the bonus provisions contained in this Division, the floor area ratio for Bonus Area F may be increased to a maximum of:
b
9.0, where the additional floor area ratio above 8.0 may only consist of units or Hotel guest rooms or both.
Bonus Area G
1201.2
In accordance with the bonus provisions contained in this Division, the floor area ratio for Bonus Area G may be increased to a maximum of 9.0, where the additional floor area ratio above 7.0 may only consist of units or Hotel guest rooms or both.
Bonus Area H
1201.3
In accordance with the bonus provisions contained in this Division, the floor area ratio for Bonus Area H may be increased to a maximum of:
b
12.0, where the additional floor area ratio above 8.0 may only consist of units or Hotel guest rooms or both.
Heritage Density Transfer Increase
1202
Notwithstanding sections 1197 to 1201.3, the maximum floor area ratio with bonuses for Bonus Area A through H may be increased by an additional 10 per cent where:
a
the additional 10 per cent floor area ratio is gained through a heritage density transfer from a site other than the development site, as defined for the purposes of this Division in Table 6.1; and
Density Transfer Limitation
1205
1
There is no provision for density transfer from one parcel to another other than those bonus earning items listed in Table 6.1.
2
Bonus earning items listed in Table 6.1, heritage density transfer and park dedication transfer, may be from source sites located outside the bonus area boundaries set out in section 1196 and shall be located within the community in accordance with the purpose statements of the CC-MH, CC-MHX, CC-X and CC-COR districts as specified in section 1122(e), 1132 (e), 1162(e) and 1179(f).
Incentive Density Calculation Method
1216.1
1
The amount of additional gross floor area achieved by providing the requirements of the public amenity items in Table 6.1 are calculated as a floor area ratio, an Incentive Ratio or an Incentive Rate.
2
An Incentive Rate indicates that the amount of additional gross floor area will be calculated by dividing the cost of the provided public amenity item in Table 6.1 by the respective Incentive Rate as established by Council where the following Incentive Rates apply:
3
Public amenity items that must or may be provided to achieve additional gross floor area are shown in Table 6.1.
6
Unless otherwise specified in this Part, a Public Amenity Item for which additional gross floor area has been achieved must be maintained on the parcel for so long as the development exists.
7
The Development Authority must determine whether a proposed Public Amenity Item is appropriate for the development.
Table 6.1: Beltline Density Bonus Items
