Land Use Bylaw1P2007

Bylaw test

Top of page

PART 7: COMMERCIAL DISTRICTS

Division 10: Commercial – Regional 1 f# (C-R1 f#) District

Purpose

843 1 The Commercial — Regional 1 District is intended to be characterized by:
a large "big box" single entry, mostly single use buildings;
b large retail sales activities where the product is displayed outdoors;
c large building supply contractors and garden centres selling and keeping product outdoors that would not be appropriate in other commercial or industrial districts;
d locations on or near major roads or along major commercial corridors;
e locations in industrial areas;
f primary access by motor vehicles to parcels from streets;
g pedestrian connections from public sidewalks to and between buildings;
h parcels that, through building location, setback areas and landscaping, limit the effect of large uses on nearby residential areas;
i be compatible with Industrial Business, Industrial Edge and Industrial General Districts;
j higher standards of building and parcel design only where development is along major roads, gateways and in instances where visibility and aesthetics are identified as planning concerns; and
k varying building density established through maximum floor area ratios for individual parcels.
2 Areas of land greater than 6.0 hectares should not be designated Commercial — Regional 1 District.

Permitted Uses

844 The following uses are permitted uses in the Commercial — Regional 1 District:
a Park;

Discretionary Uses

845 The following uses are discretionary uses in the Commercial — Regional 1 District:
p deleted
s deleted;
u deleted
u.1 deleted
cc.1 deleted

Rules

846 In addition to the rules in this District, all uses in this District must comply with:
a the General Rules for Commercial Land Use Districts referenced in Part 7, Division 1;
b the Rules Governing All Districts referenced in Part 3; and
c the applicable Uses And Use Rules referenced in Part 4.

Parcel Area

847 The area of a parcel must be a minimum of 0.5 hectares and a maximum of 6.0 hectares.

Floor Area Ratio

848 The maximum floor area ratio for parcels designated Commercial — Regional 1 District is the number following the letter "f" indicated on the Land Use District Maps.

Building Height

849 The maximum building height is 15.0 metres.

Buildings

850 1 Every parcel in the Commercial — Regional 1 District must have one building that is equal to or exceeds 3600.0 square metres of gross floor area.
2 In addition to the building required by subsection (1), a parcel may have up to two buildings, so long as no additional building exceeds 360.0 square metres in gross floor area.
3 The maximum number of buildings on every parcel is three.

Use Area

851 1 Only one use area in a building in the Commercial — Regional 1 District must be equal to or greater than 3600.0 square metres.
2 The maximum use area for an Office is 360.0 square metres.

Building Entrance Features

852 The public entrances must be accentuated by a minimum of one example of three or more of the following features:
a arcades;
b arches;
c awnings;
d pitched or raised cornice roof forms;
e porticoes;
f recesses or projections; or
g windows.

Front Setback Area

853 The front setback area must have a minimum depth of 6.0 metres.

Rear Setback Area

854 1 Where the parcel shares a rear property line with a parcel designated as:
a Commercial — Regional 1 District, there is no requirement for a rear setback area;
b any other commercial district, the rear setback area must have a minimum depth of 3.0 metres;
c an industrial district, the rear setback area must have a minimum depth of 3.0 metres;
d a residential district, the rear setback area must have a minimum depth of 6.0 metres; and
e a special purpose district, the rear setback area must have a minimum depth of 6.0 metres.
2 Where the parcel shares a rear property line with:
a an LRT corridor or street, the rear setback area must have a minimum depth of 6.0 metres;
b a lane that separates the parcel from a parcel designated as a residential district, the rear setback area must have a minimum depth of 6.0 metres; and
c a lane, in all other cases, the rear setback area must have a minimum depth of 3.0 metres.

Side Setback Area

855 1 Where the parcel shares a side property line with a parcel designated as:
a Commercial — Regional 1 District, there is no requirement for a side setback area;
b any other commercial district, the side setback area must have a minimum depth of 3.0 metres;
c an industrial district, the side setback area must have a minimum depth of 3.0 metres;
d a residential district, the side setback area must have a minimum depth of 6.0 metres; and
e a special purpose district, the side setback area must have a minimum depth of 6.0 metres.
2 Where the parcel shares a side property line with:
a an LRT corridor or street, the side setback area must have a minimum depth of 6.0 metres;
b a lane that separates the parcel from a parcel designated as a residential district, the side setback area must have a minimum depth of 6.0 metres; and
c a lane, in all other cases, the side setback area must have a minimum depth of 3.0 metres.

Landscaping In Setback Areas

856 1 Where a setback area shares a property line with an LRT corridor or street, the setback area must:
b provide a minimum of 1.0 trees and 2.0 shrubs:
i for every 35.0 square metres; or
ii for every 50.0 square metres, where irrigation is provided by a low water irrigation system.
2 Where a setback area shares a property line with a parcel designated as a residential district, the setback area must:
b provide a minimum of 1.0 trees:
i for every 30.0 square metres; or
ii for every 45.0 square metres, where irrigation is provided by a low water irrigation system; and
c provide trees planted in a linear arrangement along the length of the setback area.
3 Where a setback area shares a property line with a lane or a parcel designated as a commercial, industrial or special purpose district, the setback area:
b may have a sidewalk along the length of the building; and
c must provide a minimum of 1.0 trees and 2.0 shrubs:
i for every 35.0 square metres; or
ii for every 50.0 square metres, where irrigation is provided by low water irrigation system.

Minimum Required Motor Vehicle Parking Stalls

857 deleted

Excess Motor Vehicle Parking Stalls

858 Where the number of motor vehicle parking stalls required for uses is in excess of 6.0 stalls per 100.0 square metres of gross usable floor area, those excess stalls must be located in either underground or structured parking.

Exclusive Use of Motor Vehicle Parking Stalls

859 deleted

Required Bicycle Parking Stalls

860 1 The minimum number of bicycle parking stalls — class 1 for all uses is the minimum requirement referenced in Part 4.
2 The minimum number of bicycle parking stalls — class 2 is 5.0 per cent of the required number of motor vehicle parking stalls.

DISCLAIMER: This version of Bylaw 1P2007 MUST NOT be relied upon; it is not an official version of the bylaw and may contain errors. The City of Calgary accepts no responsibility to persons relying solely on this information. Consult the Office of the City Clerk for an official version of the bylaw, if required. Please note that web pages are updated periodically.